one stop cooling and heating tampa, air conditioning repair tampa, tampa air conditioning repair 24 hour, northside air conditioning tampa, air conditioning service tampa, budget ac tampa, budget heating & ac inc tampa fl, expert & quality ac, tampa

Heat pump won't turn on in heat mode

If your heat pump is not turning on in heat mode, there are several possible reasons for this issue. Here are some common causes and troubleshooting steps:

  1. Thermostat Settings: Double-check the thermostat settings to ensure that it is properly set to heat mode. Verify that the temperature setting is higher than the current room temperature. Additionally, make sure the thermostat is functioning correctly and has fresh batteries if needed.

  2. Tripped Circuit Breaker or Blown Fuse: Check the circuit breaker panel to see if the breaker for the heat pump has tripped. If it has, reset it. Similarly, inspect the heat pump's electrical disconnect switch and ensure that it is turned on. Replace any blown fuses as necessary.

  3. Outdoor Unit Issues: Inspect the outdoor unit of the heat pump. If it is covered in ice or snow, it could indicate a defrost cycle in progress. In this case, wait for the defrost cycle to complete, and the unit should resume normal operation. However, if the outdoor unit is dirty or obstructed by debris, clean it and remove any obstructions to ensure proper airflow.

  4. Faulty Thermostat or Wiring: A malfunctioning thermostat or faulty wiring can prevent the heat pump from turning on in heat mode. Consider checking the thermostat wiring connections and ensuring they are secure. If you suspect an issue with the thermostat, it may be necessary to replace it or contact a professional for further evaluation.

  5. Low Refrigerant Levels: Insufficient refrigerant levels can cause the heat pump to malfunction. If you suspect a refrigerant leak, it's essential to contact a qualified HVAC technician to diagnose and repair the leak, as well as recharge the refrigerant to the appropriate level.

  6. Other Mechanical or Electrical Issues: Several other mechanical or electrical problems can prevent the heat pump from turning on in heat mode. These may include a faulty compressor, defective fan motor, or malfunctioning sensors. It's recommended to contact a professional HVAC technician to diagnose and resolve these issues.

If you have gone through these troubleshooting steps and are still unable to resolve the problem, it is best to contact a qualified HVAC technician, such as AC Plus Heating & Air at 813-422-1111, who can accurately diagnose the issue and provide the necessary repairs to get your heat pump functioning properly again.

Back to blog